Yes, the 12V PWM Filter for RV Backup Camera Systems # VGR64VR will allow you to use the Furrion Camera System # FOS05TASF on your trailer pulled by your 2020 Mercedes Benz GLE 350. This is designed to remove the Pulse Width Modulator power and give the camera the 12-volt constant power it needs.
We also have the 7-Way Vehicle Power Adapter # FR87PR from Furrion that plugs in line of the 7-way if you would rather not splice into the wiring on your trailer. view full answer...
We don't have a database that tells us what the stud size is on that hub, but I was able to do a little bit of research and find some reports that say that your 1/2" thread by 2" long stud seems to be accurate. For that size wheel stud you can use the Redline # 7-122 lug studs you were looking at which are 2" long and have 1/2" threads. view full answer...
In order to determine what vent cover replacement is needed for your 2008 Keystone Hideout Travel Trailer you will just need to identify the hinge type.
For example, if you have a closed continuous hinge, you can use the Metal Low Profile Replacement Cover # BV0534-00,
Or,
If you have a continuous hinge that is not closed, you can use the Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent # BVD0449-A03,
Or,
If you have a 4-point hinge, you can use the Camco Replacement... view full answer...
When it comes to checking your retract/extend functions not working it sounds like you may just need to swap some wiring on the back. I will attach picture of the wire swaps. It sounds funny but per the manfuacturer that does seem to help. If that doesn't work I would recommend purchasing the new replacement head # LC285160.
I attached a review video link below. view full answer...
The answer to your question depends on the availability of hubs for your axles. Also, if you don't have a zerk fitting on the end of your spindle then you would be correct, those aren't E-Z Lube axles. I'm not sure which 2017 Keystone Hideout model you have, but you will need to find out what bearings you currently have in order to choose the correct replacement hub and drum assembly.
More than likely you have 3,500 lb axles using # L68149 inner and # L44649 outer bearings. If that is... view full answer...
I took a look at the wheel lug stud LCI SKU 121803 you mentioned, and I was able to find the Kodiak Wheel Bolt # K12WB2.
This bolt is 2" long, and has a thread size of 1/2"-20 UNF-2A. view full answer...
Thank you for the photo and the "SC = 68.50" means you have a spring-center to spring-center length of 68-1/2 inches and the "D35" means the axle is rated for 3,500 lbs. While we do not carry any axles with those specifications we do have a great solution, the Timbren Axle-Less Trailer Suspension System.
These are really an improvement over a traditional through-axle because they offer you an improved ride. They work independently (as opposed to an axle which is connected by a beam) so... view full answer...
Go To Results